Glossary entry (derived from question below)
engleză term or phrase:
top-bearing template
română translation:
freză cu rulment sus pentru copiere şablon
Added to glossary by
Alexandranow
Aug 30, 2013 11:45
10 yrs ago
engleză term
România
Quality in due time!
Native in: română
Works in: din română în engleză, din engleză în română, din română în italiană, and 1 more.
top-bearing template
din engleză în română
Altele
Artă, Arte şi meşteşuguri, Pictură
woodworking
http://americanwoodworker.com/blogs/tips/archive/2010/01/12/...
Use this template-rounding jig on a router table to cut half-circles on the ends of wooden supports
or anywhere you need a specific radius on the ends of stock. Rip the stock to finished width and
about 1/8 in. over length; then bandsaw a curve on the ends slightly bigger than the desired radius.
Using a top-bearing template or pattern bit, rout each support in four consecutive passes, each
pass cutting one corner of the support.
Use this template-rounding jig on a router table to cut half-circles on the ends of wooden supports
or anywhere you need a specific radius on the ends of stock. Rip the stock to finished width and
about 1/8 in. over length; then bandsaw a curve on the ends slightly bigger than the desired radius.
Using a top-bearing template or pattern bit, rout each support in four consecutive passes, each
pass cutting one corner of the support.
Proposed translations
(română)
| 4 | freză cu rulment sus pentru copiere şablon |
crocox
|
Proposed translations
22 ore
Selected
freză cu rulment sus pentru copiere şablon
'a top-bearing template or pattern bit' este o altă denumire a aceluiaşi tip de freză, care se foloseşte pentru decuparea lemnului după un şablon
'There are three basic template router bits: a pattern bit with a top bearing, a flush-trim bit with a bottom bearing and a straight bit combined with a guide bushing which fits in a router’s baseplate. '
http://americanwoodworker.com/blogs/tips/archive/2010/01/12/...
'There are three basic template router bits: a pattern bit with a top bearing, a flush-trim bit with a bottom bearing and a straight bit combined with a guide bushing which fits in a router’s baseplate. '
http://americanwoodworker.com/blogs/tips/archive/2010/01/12/...
Note from asker:
| mulțumesc |
4 KudoZ points awarded for this answer.
Discussion